Setting WattTech Timers

  • Follow the steps below to set the current time:
    • press the R button to reset the timer ; and press the SWITCH/OFF button;
    • press and hold the ENTER button till the number flashes;
    • Set the clock to your local time by pressing the HOUR / MINUTE button, and press ENTER to confirm.
  • Follow the steps below to set the “10mins on 20mins off” cycle timer in the MIN/SEC mode:
    • press the SWITCH/OFF button;
    • press and hold the CYCLE SETTING button for about 3s until the screen flashes;
    • press the HOUR button to set the “10mins on” time; ( in this mode, the HOUR button is used to set the desired minutes, and the MINUTE button is used to set the desired seconds)
    • short press CYCLE SETTING button, and then press the HOUR button to set the “20 mins off” time;
    • press ENTER to confirm and save the cycle timer.
  • Follow the steps below to set the daily timer: 7:00 on ~22:00 off.
    • press the SWITCH/OFF button;
    • press the TIMING SETTING button, press the HOUR button to set the on schedule 7:00;
    • press the TIMING SETTING button again, press the HOUR button to set the off schedule 22:00;
    • press the ENTER button to confirm the daily timer setting.
  • Press and hold the CYCLE SETTING button until you can see the bell symbol flashing.
  • Plug the timer into an active wall socket to see if it works correctly.